i have an 01 z24 and i had just tried to put a catback exhaust on it but found the flange was too rusted. i was looking into getting headers thinking it has the other half of the exhaust system but it looks like its still missing the midpipe section. does anyone know of a site that sells an everything but catback exhaust? thanks.
there is not kit for it. gonna have to have a shop weld some pipe

My car may run 18s, but I can do your taxes in 10 seconds flat.
JBO lube - they would never have enough in stock and we'd never see RodimusPrime again
The part you are wanting is a factory, or stock replacement cat assembly. Very expensive. Advice given by Machzel08 would be cheaper by a long shot. If you are dead set on having a flange, a muffler shop should easily be able to cut the rusty one off and weld a new one on. I would get it welded straight up w/no flange though, less chance for leaks.
well, if you do it the absolute best way possible you can get the mandrel bent downpipe, high flow cat and some piping done (all 2.5"), welded and installed for around $230.00, give or take.
if you go with crush bent piping and dont mind about size etc. you could probly get it all done for like $75.00
every shop is different though, just check around and ask.
thanks guys, i'll take it to a shop around here then.