Hello everyone i have a 95 2200 motor and i am doing a complete motor rebuild and put my turbo manifold on the block tonight and upon reinstalling the exhaust manifold bolts/ studs, i noticed that two of the studs with the bolts on them were threading funny, so i pulled them back out and noticed that they were slightly bent, is this from getting too hot or something? the motor didn't have any problems when i tore it apart, also i was wondering if anyone had the tightening sequence for the bolts i found the 2.3 and 2.4 in the chiltons but not the 2.2 2200, i was going to go the the boneyard and get those two unless someone has some on here, thanks in advace,
jason
gmto2nr@yahoo.com